hi alogeno! Glad you are having fun.
Firmware 2.3 freaks me out.
There is no way to reset floor, and the system just gets crazy confused if you try and re-center with the oculus button. Unfortunately, resetting the app is only fix right now.
I had a "floor fix" that I wrote, but it caused other problems, so didn't make it into release. I'll spend time today trying to rework it. Cross our fingers that this firmware gets patched.
In regards to floors, should the virtual floor typically be in line with the actual floor? I find that the ground is a little far away and all the furniture floats a foot off the ground. I’ve also been having an issue where after setting my space up and logging out, after I log back in my room is really zoomed out and tiny looking below me. Any advice? Thanks for the hard work, the software is amazing.
Hi man! So I'm trying a few different floor fixes, basically the oculus software tends to forget where the floor is, and you cant reset it until you turn guardian back on. So one fix is to turn guardian on, set floor, turn off, then start the app.
For your second question, this miniature view is intentional. The system should be prompting you to re-align with the anchor points. So you might have to push down on the right thumbstick, and then place the controllers down on the floor / whatever position you chose in the setup.
Hope that makes sense! Have fun with all the stuff in there!
