I do have the Z origin correctly set at the top surface and I used a XYZ probe for setting the 000. I checked the machines Z calibration. It was off slightly. I tried to rerun the job and getting the same result. I was also trying out Estlcam software and getting the same problem. I just created the same job on Openbuilds free web based CAM and the job seems to run fine. I seem to be missing something?
Viewing post in cutting too deep
Hi tdomask,
Would you mind sending G-code output by PixelCNC, EstlCAM, and the OpenBuilds CAM to us support@deftware.org? We should be able to get to the bottom of this by comparing the output of each. The situation is likely that the machine is expecting a tool Z offset which their CAM includes a command for in generated G-code.
- Charlie