Post by nesloOculus in How do you map your layout?

Custom Home Mapper (Oculus Quest) » Community

Viewing post in How do you map your layout?

i must be doing something wrongbecause i cannot figure out how to even start. i thought i had mapped my apt but when i came TPB, it did try to start with anchors but my mapping seemed super small, right around me and i cant seem to figure out the anchors. i dont see that fancy interfac from the video. please help the old guy

HeadShot5574 years ago

I have the same issue.

Dr.Killjoy013 years ago (1 edit)

I can map the walls and objects, but can't set anchors. Then I'm stuck and just have to exit the program.

CuriousVR3 years ago

Hi Kiljoy. You've run into a bug, and i'll be adding a fix for this next week.

What's happening (I think) is that you are setting your anchor down against a wall, and so the console is spawning directly inbetween these two anchor points, but is slightly behind the wall. So the process completes, you dont see a console at all (is hidden in the wall) and cannot continue.

The current 'fix' is basically to just setup with an anchor that isn't directly flush with a wall, but none of this is obvious to a new user so, mega apologies,,, you just hit a wall and couldn't continue!

Fix incoming asap

CuriousVR3 years ago

See the response above. If you cant seem to map an area bigger than a few feet around you, its because you have disabled Tracking instead of disabling the guardian.

CuriousVR3 years ago

Hey, the issue here is i think you've disabled Tracking, instead of disabling the oculus guardian. Use settings/developer/guardian OFF.

If you disable tracking, then you can't actually move within your space, and the barrier will only be a small cube that you draw around you.

itch.io

Viewing post in How do you map your layout?