i tried changing the anim_length (to 1.0) and for some reason it only applies when the sprite is first shown, it goes back to the default (0.2) setting as i put another sprite over it.
i use individual sprites but all of them are defined.
i even set it to 0.5, wondering if it was too fast to no avail.
i use NVL, if that helps.
wondered if you could look into it.
thank you very much for this btw.
Hi. Sorry for the late reply. I tried replicating the issue on my end, but doing the same setup (or at least what I can suppose from your comment) yielded results that looked correct to me. My best guess for the issue is that something about how you defined the sprites is causing renpy to reset the anim_time value, which would cause the sprite_highlight function to snap to the highlighted value. Which maybe you're confusing for the .2 seconds given .2 is pretty fast. Though I could be wrong. This is just my best guess given the information.
I tested with NVL and that didn't seem to make much of a difference. If you'd want to show me your code so I could test it and see what the issue might be, I'd be happy to take a look when I have time. (My username on discord is wattson if you need to reach out). But yeah I'm not entirely sure what the problem might be beyond my guess. Hope this was helpful and a solution to your issue can be found!
thank you for replying!
i sent you a discord req, i'd greatly appreciate if you could take a look if you do have time for it.
i don't think it's the definition because it's the exact same for every sprite and it does work for whatever that i place on the screen first, though i'd be glad to send you the code to see for yourself.
